Skip to content

Cart

Your cart is empty

Push-Pin/Threadless

When you receive your piece, it will be inserted into the labret bar. Follow the steps below to put it on correctly:

STEP 1: Separate the jewelry from the bar by gently pulling both parts outward.
If the jewelry is too tight, add a small twisting motion as you pull.
STEP 2: Once the jewel is separated from the bar, reinsert the jewel approximately halfway.

STEP 3: Slightly bend the pin with your hand, gently pressing down on the jewelry while holding the bar.

STEP 4: Separate the two pieces again, and insert the bar into your piercing from back to front, pushing the flat disc until the bar sticks out at the front.

STEP 5: Insert the pin completely into the bar, until both pieces are completely touching.

STEP 6: Push the bar back so that only the jewelry is visible at the front of your ear.
Make sure the jewelry is securely in place.

 


*If you want to remove the jewelry, repeat STEP 1.